The snow melting mat glossary
GFCI, continuous load, daisy chain, melt rate: heated mat listings and manuals use a vocabulary of their own. This page explains the 35 terms you will meet most often, each in a few sentences and tied to the five mats in our lineup.
These are the words that turn up again and again on heated mat listings, in HeatTrak’s FAQ and in everyday electrical advice, sorted from A to W. Each entry points to the guide that goes deeper.
The figures come from the five mats in our guide to the best snow melting mats. You can compare them side by side in the comparison table on the homepage.
A
- Ambient temperature
- The temperature of the air around the mat. HeatTrak says its surface runs about 40 °F above ambient, and the walkway listings rate the mats as working well as low as -8 °F. Wind and a falling thermometer both eat into that margin, as our guide to heavy snow and deep cold explains.
- Amp
- Short for ampere, the unit of electrical current. Watts equal volts times amps, so a HeatTrak walkway mat drawing 2.5 A at 120 V uses about 300 W, while a stair tread draws 0.7 A and the entrance mat 1.9 A. Adding up the amps keeps you within a Power Unit or a circuit, as our guide to amps and outlets shows.
C
- Circuit breaker
- The switch in your electrical panel that cuts power when a circuit draws too much current. A typical US household circuit is rated 15 A or 20 A, and every load on the circuit counts, mats included, along with anything like a garage freezer or porch lights. If a breaker trips when the mats switch on, our breaker guide walks you through the sums.
- Composite decking
- Deck boards made from a blend of wood fiber and plastic. HeatTrak’s FAQ asks for a non-staining barrier between mat and boards, and names 1/8 in plywood, silicone mesh or a polypropylene outdoor rug as options, while ruling out vinyl and rubber. Wood decks need no barrier, per the same FAQ, and our guide to decks and surfaces has the details.
- Connector
- The fitting where one HeatTrak mat plugs into the next, or into an extender or the Power Unit. HeatTrak describes its connectors as patented and watertight. At the end of winter the FAQ asks you to cap the fittings or wrap them in electrical tape, as our care and storage guide explains.
- Continuous load
- A load that runs for hours at a stretch, like a mat left on through a storm. Under the National Electrical Code’s rule of thumb, such a load should use no more than 80% of the breaker rating, so a 15 A circuit tops out at 12 A. Our guide to outlets and circuits shows how a chain of mats fits under that line.
D
- Daisy chain
- Linking mats end to end so that several run from one outlet. HeatTrak walkway and stair mats chain from one Power Unit to a limit of 13 A, by HeatTrak’s FAQ (a few listings give 14), while Toriexon says its mats may connect up to 1,500 W in total. The HeatTrak entrance mat cannot join a chain at all, and our mat size guide helps you plan one.
- De-icer
- Any product spread on a path to melt ice, from rock salt to chemical blends. A heated mat does the same job with no residue left behind on steps or lawn. How the two approaches compare is covered in mat, salt or heat cable.
E
- Embedded system
- A snow melting system built into a driveway or path, with heating cable or tubing laid under the surface when it is poured or paved. It has to be planned at build time, while a mat sits on top and comes indoors for summer. We review no embedded systems and give no figures for them; the trade-offs are outlined in our comparison of mats and salt.
- Entrance mat
- A heated door mat for the spot right outside a door. At 24 × 36 in, the HeatTrak entrance mat draws 1.9 A and ships with its own GFCI power unit, so it is a standalone mat that cannot connect to others. Where it fits in a layout is covered in our guide to how many mats you need.
- ETL listing
- A safety mark from the testing lab Intertek, showing that a product sample met a recognized safety standard. The Toriexon listing claims UL and ETL certification for the mat’s outdoor cord and plug. Look for the mark on the cord or label itself, as our snow melting mat safety guide suggests.
- Extender cable
- HeatTrak’s own extension cable, sold in watertight 10 ft and 25 ft lengths with its patented connectors, which can be chained. The listing says they suit a mat more than 6 ft from the outlet, since the Power Unit cord is 6 ft long. The 10 ft extender sits in the $ band, as our guide to a cheap snow melting mat notes.
- Extension cord
- A general-purpose cord between the outlet and the mat or Power Unit. HeatTrak’s FAQ accepts any outdoor-rated cord that is 14-gauge or heavier, as long as you keep the connection away from water. Never run one under a door or across a walking line, as our guide to cords and safety explains.
G
- GFCI
- Ground-fault circuit interrupter, a device that cuts power within a fraction of a second when current leaks to ground, through water or a person. The National Electrical Code requires GFCI protection for outdoor receptacles, and the HeatTrak Power Unit has one built in that trips at more than 6 mA. The Toriexon relies on the outlet’s GFCI instead; see our guide to GFCI and mat safety.
- Grommet
- A reinforced hole near the edge of a mat for a stake, screw or tie. The HeatTrak entrance mat has four 3/8 in grommets for optional securing, while no fixing points are stated for the other four mats in our lineup. How to keep a mat in place on different surfaces is covered in our guide to wood, composite and concrete.
H
- Heat cable
- A heating cable run along a roof edge or gutter, or laid under a path, to stop ice from forming. It works where a mat can’t lie, but it stays fixed in place rather than coming in each spring. Our guide to mats, salt and heat cable weighs the options against each other.
- Heating element
- The resistive wiring inside a mat that turns electricity into heat. HeatTrak’s elements sit between two non-slip rubber surfaces, per its FAQ, and like every resistive heater they turn all of their power into heat. How that heat reaches the snow is explained in how heated mats melt snow.
I
- In-use cover
- A weatherproof hood, often called a bubble cover, that closes over an outdoor outlet while something is plugged in. Any outlet feeding a mat all winter should have one, along with GFCI protection. Our safety guide shows what a safe outdoor outlet looks like.
K
- Kilowatt-hour
- The unit your power bill counts, 1,000 W used for one hour. Watts times hours divided by 1,000 gives kWh, so a 300 W walkway mat running 10 hours uses 3 kWh, which you multiply by the rate on your bill. By HeatTrak’s own estimate, running a typical set comes to roughly 18 cents an hour, and our guide to running cost works through the arithmetic.
M
- Melt rate
- How much snow a mat clears per hour. HeatTrak and the Toriexon listing both claim up to 2 in per hour, and the result on your steps depends on wind, air temperature and how hard the snow falls. Our guide to how snow melting mats work explains the physics, and when a mat falls behind covers big storms.
N
- NEC
- The National Electrical Code, the US model code for safe wiring that states and towns adopt. It requires GFCI protection for outdoor receptacles, and its 80% rule of thumb for continuous loads keeps a 15 A circuit at 12 A. When in doubt, ask an electrician, and read our guide to amps and outlets first.
- Non-slip surface
- A textured top that gives shoes grip even when wet. HeatTrak uses rubber on both sides of its heating element and a textured thermoplastic on the entrance mat, and Toriexon calls its surface anti-slip. Owners of some unbranded mats complain of slippery tops, as our budget mat guide explains, and steps are where grip matters most, per our heated stair mat guide.
O
- Outdoor outlet
- A weather-resistant 120 V receptacle outside the house; HeatTrak’s residential mats use the standard NEMA 5-15 plug. It needs GFCI protection plus an in-use cover. Which outlet and circuit to use is covered in will it trip the breaker.
P
- Power Unit
- HeatTrak’s outdoor-rated control box, holding a GFCI and a 6 ft cord, which every HeatTrak walkway and stair mat needs. A single unit handles at most 13 A of mats, according to HeatTrak’s FAQ (other listings say 14); past that, you add a second unit on another outlet or circuit. The HeatTrak walkway mat with Power Unit includes one, and our amps guide shows how to share the load.
R
- Rock salt
- Sodium chloride, the most familiar de-icer. It stops working well below about 15 °F and can harm concrete, plants and pets’ paws, all of which a mat avoids. Our guide to mats against salt compares the two.
- Runner
- A long, narrow heated mat for a path. The unbranded 13 in × 10 ft runners we looked at drew owner reports of tripped breakers and short lives, so we left them out. A row of 20 × 60 in walkway mats on one Power Unit covers the same ground, as our guide to a snow melting mat under $150 explains.
S
- Stair tread
- A narrow mat sized for one step. HeatTrak’s 10 × 30 in tread draws 0.7 A and also comes in 10 × 48 and 10 × 60 in, while Toriexon sells 10 × 30 in mats in packs. Our guide to heated mats for steps covers fit and layout.
- Standalone mat
- A mat that plugs into its own outlet and does not join a chain. The HeatTrak entrance mat is one, with its own GFCI unit, while the Toriexon has its own plug but can still connect to other Toriexon mats. Our mat size guide explains when a single mat is enough.
- Surface temperature
- How warm the top of the mat gets. HeatTrak says the top of its mats sits about 40 °F warmer than the surrounding air, so by that rule a 10 °F night would leave the mat around 50 °F. The physics behind it is in how heated mats melt snow.
T
- Thermostat
- A control that switches heat on and off to hold a set temperature. None of the five mats in our lineup lists a thermostat, so they heat whenever they are switched on. According to HeatTrak’s FAQ, running its mats all winter long causes them no extra wear, and our running cost guide shows what those hours add up to.
U
- UL listing
- A mark from Underwriters Laboratories (UL) showing that a product met a published safety standard. The Toriexon listing says its cord and plug carry UL and ETL certification for outdoor use. Check for the mark on the product itself, as our snow melting mat safety guide advises.
V
- Voltage
- The electrical pressure an outlet supplies; standard US household receptacles deliver 120 V. Every mat in our lineup runs on 120 V, and a 120 V mat will not work on 230 V European mains. A listing claiming one mat runs on 110 V to 240 V is a red flag, and our guide to amps and outlets covers the US basics.
W
- Walkway mat
- A wider mat for paths, porches and landings. HeatTrak’s 20 × 60 in walkway mat is about 0.5 in thick, weighs 8.28 lb and draws 2.5 A, and it also comes in 20 × 30, 30 × 30 and 30 × 60 in, the largest at 3.5 A per a dealer listing. How many you need is the subject of our mat size guide, and this mat is the top pick on our homepage.
- Waterproof rating
- A statement of how well a product keeps water out. Toriexon calls its mat waterproof and HeatTrak says its mats are designed to be left out all season, but neither listing gives a formal rating number. Keep connections out of standing water either way, as our care and storage guide explains.
- Watt
- The unit of power, equal to volts times amps. Our five mats range from about 84 W for a HeatTrak tread to 330 W for the Toriexon, whose 36 × 72 in sibling draws 730 W. A mat’s watts decide how fast it melts, along with the weather, and our guide to running cost turns watts into kWh.