HeatTrak walkway mat or starter mat, one heated mat in two boxes

HeatTrak sells its 20 × 60 in walkway mat two ways, on its own or with the Power Unit attached. The heat is identical, so the choice depends on whether a Power Unit already sits on your porch.

Same mat, so pick by the Power Unit you already own

The HeatTrak HR20-60 and the HR20-60P carry the same 20 × 60 in mat with the same 2.5 A heating element. The only difference is in the box, since the P version ships with the HeatTrak Power Unit attached and the plain mat ships without one.

Pick the HeatTrak mat with Power Unit if this is your first HeatTrak mat, because it heads the chain. Pick the plain HeatTrak walkway mat when a Power Unit already waits by your outlet and you want more heated path.

Both appear on our list of the best snow melting mats, the plain mat as pick 1 and the boxed version as pick 4. If your path ends in steps, read stair treads or a walkway mat, and the starter mat meets a plug-in rival in starter mat or Toriexon.

The plain mat and the starter mat side by side

Figures come from the two Amazon listings and HeatTrak’s residential FAQ. Coverage and watts are our own arithmetic from the listed size and amps.

FeatureHeatTrak walkway mat (HR20-60)HeatTrak mat with Power Unit (HR20-60P)
Size20 × 60 in, about 0.5 in thickThe same mat and thickness
Coverage1,200 sq in, about 8.3 sq ftSame 8.3 sq ft
Power draw2.5 A at 120 V, about 300 W2.5 A for this mat, about 300 W
Power unit neededYes, sold separatelyIncluded and attached
GFCIInside the Power Unit you addInside the included unit, trips above 6 mA leakage
ChainingJoins a chain behind a Power UnitHeads a chain, capped at 13 A by HeatTrak’s FAQ (14 on some listings)
Melt rateAs much as 2 in of snow each hour, says HeatTrakSame figure
Cold ratingSurface held roughly 40 °F over air temperature, rated to -8 °F (listing)Same figures
FixingNone named on the listingNone named either
Weight8.28 lb9.63 lb with the unit
Owner feedbackThe most-reviewed snow melting mat on Amazon; top complaint is the missing Power UnitFewer reviews; buyers say the extra cost pays off, energy use opinions mixed
Warranty2 years from shipment2 years from shipment
Price band$$, plus a Power Unit for a first mat$$$, just over $250

Heat and melting come out level

Both use the identical 2.5 A element on 120 V, roughly 300 W once you multiply it out. HeatTrak claims either one clears as much as 2 in of snow an hour while holding the surface near 40 °F above the air temperature.

The walkway listings add that the mat works well down to -8 °F. Since the same mat sits in both boxes, the melting on your path will match, and our guide to how heated mats melt snow explains why watts set the pace.

Round goes to neither, a draw.

The Power Unit decides your first purchase

A plain HR20-60 does nothing until you plug it into a HeatTrak Power Unit. That surprise is the most common owner complaint on its listing, from buyers who unpacked the mat and found no way to connect it to the wall.

The HR20-60P removes that trap. Its unit is outdoor-rated, holds the GFCI and has a 6 ft cord, so on delivery day you can plug the mat into a GFCI-protected outdoor socket that has an in-use cover.

If you buy the plain mat as your first, plan for the mat plus a separate Power Unit. Our guide to amps and outlets explains why one unit can serve a whole chain of mats.

Round goes to the starter mat for a first purchase.

Extending a chain favors the plain mat

Once a Power Unit sits by the outlet, a second one on the same chain adds nothing. Every extra mat plugs into the one before it, so the plain HR20-60 is the sensible way to add another 60 in of heated path.

The budget is 13 A per Power Unit per HeatTrak’s FAQ, though some listings say 14. At 2.5 A per walkway mat, five mats come to 12.5 A, and the manual’s own example runs three walkway mats with five stair treads for 11 A.

Your circuit is the second ceiling. Hold a continuous load to no more than 80 percent of the breaker rating, roughly 12 A on a 15 A circuit, and count a garage freezer sharing that breaker. If you are unsure, ask an electrician.

Round goes to the plain mat for adding length.

Laying out and plugging in

Each mat is about 0.5 in thick and designed to be left out all season. The boxed version weighs 9.63 lb with its unit against 8.28 lb for the plain mat, so either is light enough to carry to the porch and lay flat.

The outlet rules match too. If the mat sits more than 6 ft from the outlet, use HeatTrak’s watertight 10 ft or 25 ft extenders or an outdoor-rated 14-gauge cord, with every joint kept out of water.

Never run a cord under a door, where it gets pinched, or across the line people walk. Our snow melting mat safety guide covers cords, GFCI and placement in more detail.

A draw, the setup rules are the same.

Owner records and the price band

Among heated mats on Amazon, the plain one is the most-reviewed. Owners say it works on porches and steps, heats up quickly and holds up, though some describe failures after about five years and value opinions are mixed.

The boxed version has fewer reviews on its own listing, but the mat inside is identical. Its buyers call it effective on walkways and doorways and easy to install, and they are split on energy use.

The plain mat sits in the $$ band without a unit, and the starter lands in the $$$ band, just over $250, because the unit is in the box. HeatTrak’s own estimate for running a typical set is about 18 cents an hour.

Round goes to the plain mat for the deeper owner record.

Warranty and care across the seasons

Both come with HeatTrak’s 2-year warranty, counted from shipment, which covers defects and excludes improper use or incorrect installation. With proper care, the FAQ expects an average life of 5–6 years.

At season end, let the mats cool, store them flat in a dry place and protect the connector fittings with their caps or a wrap of electrical tape. Never cut a mat, and keep shovels, ice chippers and snow blowers off its surface.

A draw on warranty and care.

The starter mat only looks like the dearer choice on the listing page. A first-time buyer of the plain mat still needs a Power Unit before anything melts, so compare the starter against the plain mat plus a unit, never against the bare mat.

For a long chain, buy one starter and plain mats for the rest. A second unit only makes sense once your chain passes 13 A and needs its own outlet on another circuit.

First mat or next mat

If no HeatTrak Power Unit sits by your outlet yet, the HR20-60P is the one to order, because it works out of the box. If you already own a unit, the plain HR20-60 adds 60 in of heated path for a band less.

Questions and answers

More questions about the plain mat and the starter mat

Is the HR20-60P a different mat from the HR20-60?

No. Each box holds the identical 20 × 60 in HeatTrak walkway mat, rated 2.5 A on 120 V. The HR20-60P simply arrives with the HeatTrak Power Unit already attached, and that unit carries the GFCI plus a 6 ft cord.

Will the plain HeatTrak walkway mat work on its own?

No. Nothing heats until you connect a HeatTrak Power Unit, which is sold on its own. Owners name the missing unit as their most common complaint, so add one to your order if this is your first mat.

What is the most walkway mats a single Power Unit can handle?

Each unit can carry 13 A according to HeatTrak’s FAQ, or 14 A according to some listings. Five walkway mats at 2.5 A apiece total 12.5 A. Your circuit has to carry that too, so count other loads on the same breaker.

Should I buy two starter mats for a long path?

Usually not. One starter mat begins the chain and plain mats plug in behind it. A second Power Unit only helps once the chain passes the 13 A budget and needs another outlet on another circuit.

Do the two versions carry the same warranty?

Yes. Each has a 2-year HeatTrak warranty starting on the shipment date, which covers defects and excludes improper use, incorrect installation or abuse. The FAQ expects them to last 5 to 6 years on average if cared for properly.