HeatTrak stair treads or one Toriexon, which snow mat suits your steps?

Outdoor steps are where ice hurts people, so they deserve the right mat. Narrow HeatTrak treads cover one step each, while a single wide Toriexon mat plugs in without a Power Unit but needs a flat landing to lie on.

Steps take treads, a landing can take the Toriexon

If the icy part is a flight of outdoor steps, buy HeatTrak stair mats, one 10 × 30 in tread per step, chained to a Power Unit. A 20 × 60 in mat is far deeper than a normal step, so it cannot lie flat on one without folding over the nose.

The Toriexon 20 × 60 mat fits a different job, such as a landing at the top or a deep bottom step with the ground in front of it. Pick it if one plug-in mat covers that spot and you would rather not buy a Power Unit.

Both sit on our list of snow melting mats worth buying, the treads as pick 2 and the Toriexon as pick 5. For treads against a HeatTrak runner, see stair treads or a walkway mat.

Treads and the Toriexon compared

The HeatTrak column describes one tread, so multiply the power and coverage by your number of steps. The Toriexon column describes one mat from its listing.

FeatureHeatTrak stair mat (each)Toriexon 20 × 60
Footprint10 × 30 in, roughly 0.5 in thick20 × 60 in, thickness unlisted
Area per pieceOne step, about 2.1 sq ft (our arithmetic)A landing or path, about 8.3 sq ft
Load0.7 A, roughly 84 W at 120 V330 W, roughly 2.75 A at 120 V
Extra box requiredYes, the HeatTrak Power Unit, bought on its ownNo, its plug goes straight in
GFCI locationIn the Power Unit, trips above 6 mA leakageThe outdoor outlet supplies it
Joining matsUp to 13 A of mats per Power Unit (FAQ; some listings say 14)Toriexon mats only, 1,500 W maximum
Melting claimAs much as 2 in of snow per hourAs much as 2 in of snow per hour
Low-temperature claimSurface roughly 40 °F warmer than the air (HeatTrak)Unlisted
AnchoringNone listedUnlisted
Owner reportsKeeps steps clear, easy setup; heat opinions mixedOnly a few so far
Cover period2 years after shipmentUnlisted
Cost band$ per tread$$

Which one fits a step

A HeatTrak tread is 10 in deep and 30 in wide, sized to sit on one step with the rest of the stair left bare. Owners say it feels safe on concrete steps, and at 2.89 lb it stays light enough to lift off in spring.

The Toriexon is twice as deep, so on an ordinary step half of it would hang in the air or bend down onto the riser. Never fold or cut a heated mat to make it fit, since that can damage the element inside.

Toriexon does sell 10 × 30 in pieces in packs, but this page compares its 20 × 60 single mat. Our heated stair mats guide covers measuring treads and landings in more detail.

Round goes to the HeatTrak treads, the only ones here made for a step.

A Power Unit against a plain plug

A HeatTrak tread does nothing on its own. It draws its power through the HeatTrak Power Unit, an outdoor-rated control box with the GFCI and a 6 ft cord inside, sold on its own unless you buy the walkway mat that comes with one.

The Toriexon skips that step. Its UL and ETL certified plug wants nothing more than an outdoor socket that is GFCI protected and fitted with an in-use cover, and once plugged in the mat begins to warm.

Round goes to the Toriexon, for the simpler setup.

Amps for a whole flight

Four treads draw 2.8 A, about 336 W by our arithmetic, almost the same as one Toriexon at 330 W. Five treads come to 3.5 A, still a light load for one Power Unit.

HeatTrak’s FAQ caps a Power Unit at 13 A of mats, while some listings say 14. Its manual gives an example of five stair mats plus three walkway mats drawing 11 A, leaving headroom on a 15 A circuit when no other load shares it.

On a 15 A circuit, hold continuous loads to 12 A or less, counting anything else on that breaker, such as a garage freezer. Our amps and outlets guide shows how to add it up, and an electrician can confirm what your circuit carries.

A draw, a short flight and one Toriexon pull about the same power.

Melting where your foot lands

Each mat is rated to melt as much as 2 in of snow per hour, and HeatTrak puts its surface at roughly 40 °F above air temperature. Opinions among stair mat owners divide on heat, some finding the surface very warm within 15 minutes and others saying it is not warm enough.

The Toriexon puts its 330 W into a wider area, and its listing gives no cold rating. On a landing that is fine, but on steps it simply cannot sit where your boots go.

Round goes to the HeatTrak treads, for heat placed on each step.

Record, warranty and the bill

HeatTrak stair mat owners say the treads keep steps clear, set up easily and hold up, with mixed views on price. The treads carry HeatTrak’s 2-year warranty from shipment.

Each tread sits in the $ band, under $150, but a flight adds up and the Power Unit comes on top. The Toriexon is a single $$ purchase, though owner reviews are still thin and its listing names no warranty term.

Round goes to the HeatTrak treads for the record, to the Toriexon for a single landing on a budget.

No single mat clears both the steps and the landing well. The Toriexon cannot join a HeatTrak chain, so pairing treads with a Toriexon means two plugs, ideally on two GFCI outlets, with both loads counted against the circuit.

If the landing is right at the door, a square door mat may suit it better, which HeatTrak door mat or Toriexon weighs up. Our mat size guide helps you count steps and pieces.

Treads for the stairs, one mat for the landing

For a flight of outdoor steps, HeatTrak stair mats on a Power Unit are the right tool, one tread per step with a long owner record. For a flat landing or a deep bottom step with no stairs to cover, one Toriexon plugs in and gets the job done.

Questions and answers

More questions about stair treads and the Toriexon

Can I lay a 20 × 60 Toriexon mat on a normal step?

Not properly. At 20 in deep it is about twice the depth of a HeatTrak tread, so on an ordinary step it would hang over the edge or bend down the riser. Never fold or cut a heated mat to make it fit.

Do HeatTrak stair mats work without a Power Unit?

No. Every tread gets its power through the HeatTrak Power Unit, home to the GFCI and the 6 ft cord. Buy the unit on its own, or make the first link of your chain the HeatTrak walkway mat sold with a unit included.

How many treads can one Power Unit run?

Up to 13 A of mats per unit according to HeatTrak’s FAQ, or 14 A on some listings. At 0.7 A each that is a lot of treads, but your circuit and any other mats in the chain also count.

Do four treads use more power than one Toriexon?

About the same. Four treads draw 2.8 A, roughly 336 W by our arithmetic, and the Toriexon draws 330 W. The treads spread that heat over four steps instead of one landing.

Can I mix HeatTrak treads and a Toriexon mat?

Only as two separate setups. The Toriexon cannot plug into a HeatTrak chain, so it needs its own GFCI outlet, and both loads count if they share a circuit.