HeatTrak entrance mat, a heated door mat with its own plug

The HeatTrak entrance mat is a heated door mat that carries its own GFCI power unit, so there is nothing else to buy. That same unit is why it cannot join a chain of other mats. We did not install one, so this review relies on HeatTrak’s listing and FAQ and on what owners report.

HeatTrak 24 by 36 inch black heated entrance door mat with a textured non-slip surface and a power cord Plug-in door mat

Price band $$$150 to $250 · Sold by HeatTrak, ships from Amazon

Our verdict

The entrance mat is the easiest HeatTrak to live with if all you need is a clear doorstep, since the GFCI unit and 6 ft cord come attached. It is thin, light and fixable through four grommets, and at 1.9 A it barely loads a circuit. The trade-off is that it stands alone, so you cannot add treads or a walkway mat to it later. Owners like it at the door but split on durability and heat, and a few say theirs never warmed at all.

Strengths

  • Own GFCI power unit and 6 ft cord in the box
  • Four 3/8 in grommets for fixing it in place
  • Only 1.9 A, about 228 W by our arithmetic
  • Textured non-slip surface, thin at 0.16 in
  • 2-year warranty from shipment, sold by HeatTrak

Weaknesses

  • Cannot connect to any other HeatTrak mat
  • A few owners say theirs did not heat at all
  • Durability reports are mixed
  • Owners call it expensive for its size

Buy it if

you want one heated mat at a single door, plugged into a covered GFCI outlet, with nothing else to buy or connect.

Skip it if

you plan to heat steps or a path later and want everything on one chain, or your door has no outdoor outlet nearby.

Specs: HeatTrak Entrance Mat 24 × 36 in

TypeStandalone heated door mat (cannot connect to other mats)
Size24 × 36 in, 0.16 in thick (listing)
Power draw1.9 A at 120 V (about 228 W, our arithmetic)
Melt rateUp to 2 in of snow per hour (HeatTrak)
PowerOwn power unit included: built-in GFCI, 6 ft cord, standard 120 V outlet
FixingFour 3/8 in grommets, cord locking sleeve
SurfaceNon-slip textured thermoplastic, black
Other sizes30 × 48 in and 2 ft 6 in × 4 ft
Weight6.86 lb (listing)
Warranty2 years from shipment

Data from the manufacturer’s manual and spec sheet and from the Amazon listing. Price band $$: $150 to $250. Only the price Amazon shows at checkout counts.

A 24 × 36 in mat for one doorway

At 24 × 36 in, the entrance mat covers the patch in front of one door where snow melts off boots and freezes again overnight. It is wider and shorter than the 20 × 60 in walkway mats, closer in shape to an ordinary door mat.

HeatTrak lists it in larger sizes too, including 30 × 48 in. Measure the landing outside your door first, because the mat should lie flat with no edge hanging over a step.

It is far thinner than the walkway mats at 0.16 in, against about 0.5 in, and weighs 6.86 lb. That low edge counts at a doorway, where a thick lip is one more thing to catch a toe on.

Its own GFCI unit, and no chain

The mat ships with its own power unit, which has a built-in GFCI and a 6 ft cord and plugs into a standard 120 V outlet. Unlike the plain walkway and stair mats, it needs no separate HeatTrak Power Unit.

A GFCI cuts the power when it senses current leaking where it should not, which is what you want from anything wet lying by a door. For its Power Unit, HeatTrak’s FAQ puts the trip point at more than 6 mA of leakage.

That same design is its limit. The entrance mat cannot connect to other mats, so a stair tread or walkway mat added later needs its own Power Unit on an outlet with room to spare.

Our page on a door mat or a walkway mat sets the two side by side if you are torn. One door suits this mat, while a door with steps or a path below it suits a chain.

At 1.9 A, about 228 W by our arithmetic, it is a light load for any porch circuit. Freezers and lights on that breaker still count toward the 12 A continuous limit of a 15 A circuit, so add them up before you plug in.

Melting at the door in deep cold

HeatTrak rates the entrance mat at up to 2 in of snow per hour, the same figure as its walkway mats, with the surface running about 40 °F above the air. The -8 °F figure appears on the walkway listings, not on this one.

Spread over its 6 sq ft, 228 W works out to roughly 38 W per sq ft. The walkway mat puts about 36 W into each of its 8.3 sq ft, so the heat per square foot is close.

Switch it on before the snow starts, because no mat catches up quickly once a heavy fall has buried it. Our explainer on how heated mats melt snow shows why. Ten hours at 228 W use about 2.3 kWh, and the rate on your power bill turns that into money.

Fixing it down and routing the cord

If wind or foot traffic shifts the mat, you can pin it down through its four 3/8 in grommets, though HeatTrak calls them optional. A cord locking sleeve keeps the connection to the power unit watertight.

The cord is where most mistakes happen at a door. Never run it under the door or through a gap where it gets pinched, and keep it off the line people walk.

Even though the unit carries its own GFCI, the outdoor outlet it plugs into should also be GFCI protected and wear an in-use cover. Read our guide to cords, GFCI and safety before you reach for an extension cord.

Past 6 ft of reach, choose a 14 gauge or heavier cord made for outdoor use, and keep the plug joint dry. Wood porches are fine with HeatTrak mats, while composite boards want a non-staining layer underneath made from anything but vinyl or rubber.

Thermoplastic made for a winter outside

The surface is a black, textured thermoplastic designed to stay non-slip, and HeatTrak’s FAQ expects 5–6 years from a mat on average if it is looked after. The warranty runs 2 years from shipment and covers defects, not misuse.

HeatTrak builds its mats for a full winter outdoors, and per its FAQ, keeping them powered on causes no extra wear. There is no reason to lift this one between storms.

Keep shovels, ice chippers and metal scrapers off it, and never cut it to fit a step. A soft approach to the doorstep keeps the heating element intact for years.

At the end of winter, let it cool and store it flat in a dry place. Check the cord and plug, then cap or tape the fitting, as our care and storage guide describes.

Owner reports on the door mat

Owners say it keeps entrances clear and installs easily. Many also like having the GFCI built into the unit rather than relying on the outlet alone.

The other side is harder to ignore. Durability reports are mixed and many find it expensive for its size, while heating reports range from quick warmth to a few owners whose mat did not heat at all.

Plug it in the day it arrives and leave it running for a while on a cold afternoon. If it stays cold, use the return window rather than waiting for the first storm.

Door mat, walkway mat or Toriexon

If snow piles up on the path or steps too, the HeatTrak walkway mat plus a Power Unit grows into a chain this mat never can. The starter walkway mat bundles that unit in, at the cost of the $$$ band.

The Toriexon 20 × 60 mat also plugs into an outdoor GFCI outlet without a separate unit, and it can connect to other Toriexon mats. Toriexon has few owner reviews yet and states no warranty term, where HeatTrak gives two years.

See it next to the others on our entrance mat card or in our list of heated snow melting mats for every doorstep. Both show the band, the amps and the catch of each mat at a glance.

For a single clear doorstep

If one door is the problem and you never plan to heat more, this is the tidiest fix HeatTrak makes, with its GFCI unit attached and grommets to hold it. Plug it into a covered outdoor outlet, keep the cord clear of the door, and check it heats on day one.

Questions and answers

More questions about the HeatTrak entrance mat

Can the HeatTrak entrance mat connect to other mats?

No. It is a standalone mat with its own power unit and cannot join a chain. Steps or a path need a separate Power Unit with HeatTrak walkway or stair mats.

Does the entrance mat need the HeatTrak Power Unit?

No. It comes with its own power unit, which has a built-in GFCI and a 6 ft cord that plugs into a standard 120 V outlet.

How much power does the HeatTrak entrance mat use?

HeatTrak lists 1.9 A, which works out to about 228 W at 120 V. Ten hours of running use roughly 2.3 kWh.

Can I fix the entrance mat down?

Yes. It has four 3/8 in grommets for optional securing and a cord locking sleeve that keeps the connection watertight.

Can I run the cord under my front door?

No. A cord pinched in a door gets damaged. Use an outdoor GFCI outlet fitted with an in-use cover, and lead the cord along a path nobody walks.