HeatTrak mat with Power Unit, the starter mat for a snow-free path

The HeatTrak HR20-60P is the same 20 × 60 in walkway mat as our top pick, sold with the Power Unit it needs. That makes it the first mat of a HeatTrak chain and the simplest way into the system. We did not install one, so this review leans on HeatTrak’s listing, FAQ and manual and on owner reports.

HeatTrak 20 by 60 inch heated walkway mat with the outdoor power unit and cord included Ready to plug in

Price band $$$over $250 · Sold by HeatTrak, ships from Amazon

Our verdict

The HR20-60P solves the biggest owner complaint about HeatTrak by putting the Power Unit in the box. It is the same mat as our top pick, with the same 2.5 A draw and 2 in an hour, and its unit can feed treads and more mats up to 13 A. It sits in the $$$ band, just over $250, and its own listing carries fewer reviews than the plain mat. If this is your first HeatTrak, it is the one to order.

Strengths

  • Power Unit with GFCI and 6 ft cord included
  • Same proven mat as the plain HR20-60
  • Room for treads and more mats up to 13 A
  • Owners report an easy install
  • 2-year warranty from shipment

Weaknesses

  • In the $$$ band, the priciest of the five
  • Fewer owner reviews on this listing than on the plain mat
  • A second unit is wasted if you already own one
  • Owner views on energy use are mixed
  • Can fall behind in very heavy snowfall

Buy it if

this is your first HeatTrak mat and you want one order that works on arrival and can grow into a chain of treads and mats.

Skip it if

you already own a HeatTrak Power Unit, in which case the plain HR20-60 extends your chain for less.

Specs: HeatTrak Walkway Mat with Power Unit

TypeHeated walkway mat with the Power Unit attached; first mat of a HeatTrak chain
ModelHR20-60P
Size20 × 60 in, about 0.5 in thick
Power draw2.5 A at 120 V for this mat (about 300 W, our arithmetic)
Power unitIncluded: outdoor-rated, GFCI, 6 ft cord, up to 13 A of mats
Melt rateUp to 2 in of snow per hour (HeatTrak)
Surface temperatureAbout 40 °F above the air temperature; works down to -8 °F (listing)
Other sizes20 × 30, 30 × 30 and 30 × 60 in with a unit
Weight9.63 lb (listing)
Warranty2 years from shipment

Data from the manufacturer’s manual and spec sheet and from the Amazon listing. Price band $$$: over $250. Only the price Amazon shows at checkout counts.

Same 20 × 60 in mat, unit in the box

The mat is identical to the plain HeatTrak walkway mat, 20 × 60 in and about 0.5 in thick, drawing 2.5 A. The difference is the Power Unit, which brings the listed weight to 9.63 lb against 8.28 lb for the mat alone.

The same family sells 20 × 30, 30 × 30 and 30 × 60 in mats with a unit. A 20 in width suits a path, while a 30 in mat fits a landing better.

The plain mat sits in the $$ band and this bundle in the $$$ band, just over $250. That gap between the two listings is roughly what the Power Unit adds, and the bundle spares you a second order.

A 5 ft mat rarely covers a whole walk on its own. Our guide to how many mats you need adds up paths and steps, so you can plan the rest of the chain before the first piece arrives.

One Power Unit, room for a chain

The Power Unit is outdoor-rated, with a 6 ft cord to the outlet. HeatTrak’s FAQ says its GFCI cuts the power once leakage passes 6 mA.

This mat plugs into the unit first, and more HeatTrak walkway mats and stair treads daisy-chain behind it. That is why HeatTrak calls it the starter mat, and why buying it a second time makes little sense.

One unit can carry 13 A of mats by HeatTrak’s FAQ, and some listings say 14. This mat uses 2.5 A, which leaves 10.5 A for the rest of the chain, enough for up to 15 stair treads at 0.7 A each.

A common front-door layout of this mat plus four treads draws 5.3 A, well under half the budget. The worked example in HeatTrak’s manual goes further, pairing three 20 × 60 in mats with five treads for 11 A in all.

Bar chart of the power draw of the five snow melting mats in amps at 120 volts, with the 13 amp HeatTrak Power Unit budget and the 12 amp continuous limit of a 15 amp circuit
HeatTrak gives amps; watts are our arithmetic (amps × 120 V). Toriexon gives 330 W, about 2.75 A. Everything else on the same circuit counts toward the limit too.

The circuit is the second limit. On a 15 A breaker, the usual rule of thumb leaves 12 A for a load that runs for hours, so a fully loaded unit on a breaker that also runs a freezer invites trips.

Our guide to amps, outlets and breakers does the sums for you. Beyond 13 A, HeatTrak’s answer is a second Power Unit on a second outlet or circuit, and an electrician can confirm what your outlet feeds.

How fast it clears a path

Each hour, HeatTrak says, the mat can clear up to 2 in of falling snow while its surface holds about 40 °F over the air temperature. The listing rates it down to -8 °F, and those are the maker’s figures, so expect less in a strong wind.

Turn it on before the snow, not after a foot has fallen. No thermostat is listed, and HeatTrak’s FAQ says leaving it running through the winter does not wear it out.

The mat alone draws about 300 W, which comes to 3 kWh over 10 hours. By HeatTrak’s own reckoning a typical set costs about 18 cents an hour to run, and owners are mixed on energy use.

Every mat you chain adds its own watts to that total. Our running cost guide works out bigger chains, so check your own rate before you leave a long chain on for days.

Setting up the first mat

Put the unit where its 6 ft cord reaches a GFCI-protected outdoor outlet under an in-use cover. Keep every connection out of puddles and melt water.

If the outlet is farther away, HeatTrak’s watertight 10 ft and 25 ft extenders use its own connectors. Otherwise pick an extension cord made for outdoor use, 14 gauge or heavier.

Route the cord along the edge of the path, never across it, and never through a closed door. Don’t cut a mat to fit a gap, since another size will do the job.

HeatTrak is happy with wood decks. On composite boards, put a non-staining layer underneath first, and skip vinyl or rubber for it.

Lifespan, warranty and storage

HeatTrak’s FAQ puts typical life at 5–6 years when the mat is cared for, and the warranty runs 2 years from shipment. The warranty covers defects but excludes abuse and wrong installation.

Keep shovels, metal tools, ice chippers and snow blowers off the mat. Let the heat clear it, and brush loose snow off the edges by hand if it drifts.

In spring, let the mat cool and store it flat or rolled somewhere dry and cool. Look over the cords and plugs, then fit caps on the connectors or seal them with electrical tape.

Owner feedback on the starter mat

This listing has fewer reviews than the plain mat, though the mat is the same. Owners here say it clears walkways and doorways well and installs easily.

Many buyers feel the bundled unit justifies the extra cost, while opinions on energy use are mixed. For the longer record, read the owner themes on the plain mat, including the failures some report after about five years.

Because the mat in this box is the HR20-60, that longer record applies here too. Owners of the plain mat praise how it clears porches and steps and how fast it heats, which is the same mat doing the same job.

Starter mat, plain mat or Toriexon

If you already own a Power Unit, skip this and buy the plain HR20-60 in the $$ band. If you want heated steps from day one, add HeatTrak stair treads to this unit.

The Toriexon 20 × 60 mat also plugs straight in, sits in the $$ band and draws 330 W. It relies on your outdoor GFCI outlet, with few owner reviews and no stated warranty term.

Compare all five on our starter mat card and in our heated snow mats compared table. Each shows the band and the amps, so you can see where the bundle sits.

The easy way into HeatTrak

If you have never owned a HeatTrak, this is the order that works on arrival, with the GFCI unit in the box and room for treads and more mats later. Plug it into a covered outdoor outlet and build the chain at your own pace.

Questions and answers

More questions about the HeatTrak mat with Power Unit

What is the difference between the HeatTrak HR20-60 and HR20-60P?

They are the same 20 × 60 in mat. The HR20-60P includes the HeatTrak Power Unit with its GFCI and 6 ft cord, while the HR20-60 is the mat alone.

Can I add stair mats to the HR20-60P?

Yes. Stair treads and more walkway mats daisy-chain to the included unit, up to 13 A in total per HeatTrak’s FAQ, or 14 A by some listings.

How many mats can the included Power Unit run?

Within 13 A, it runs five 20 × 60 in mats at 2.5 A each, or this mat plus up to 15 treads at 0.7 A, as long as your circuit has room.

Do I need a GFCI outlet if the Power Unit has a GFCI?

Yes. Plug the unit into a GFCI-protected outdoor outlet fitted with an in-use cover, since US code calls for GFCI protection on every outdoor receptacle.

Why does this listing have fewer owner reviews?

It is a separate listing for the mat and unit together. The plain HR20-60 is the same mat and the most-reviewed snow melting mat on Amazon, so its reviews tell you more.